TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Trailers
Keel rollers with a semi v alum boat?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="richg99" data-source="post: 171280" data-attributes="member: 4376"><p>OK I was WRONG.. After getting the trailer out in full daylight this morning, I see that the trailer guys already have the boat at its lowest possible point. Given that this trailer was never matched to this boat...they did the best they could. I could not see the stern yesterday because I had the boat jammed far back into my garage.</p><p></p><p>The stern roller looks like it will do its job. The fore roller would have to be raised ten inches to do anything at all....and it is welded on. I see no reason to change anything right now. </p><p></p><p>I know at least one launch that I can use with no troubles. I will have to try a few others over the next week or so and see if I have a problem launching/recovering. Thanks for all of the help here, anyhow. regards, Rich</p></blockquote><p></p>
[QUOTE="richg99, post: 171280, member: 4376"] OK I was WRONG.. After getting the trailer out in full daylight this morning, I see that the trailer guys already have the boat at its lowest possible point. Given that this trailer was never matched to this boat...they did the best they could. I could not see the stern yesterday because I had the boat jammed far back into my garage. The stern roller looks like it will do its job. The fore roller would have to be raised ten inches to do anything at all....and it is welded on. I see no reason to change anything right now. I know at least one launch that I can use with no troubles. I will have to try a few others over the next week or so and see if I have a problem launching/recovering. Thanks for all of the help here, anyhow. regards, Rich [/QUOTE]
Verification
Post reply
Forums
Boats
Trailers
Keel rollers with a semi v alum boat?
Top