Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="FuzzyGrub" data-source="post: 497419" data-attributes="member: 3438">Sorry.  I missed that this was a jet.   <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite11" alt=":rolleyes:" title="Roll eyes    :rolleyes:" loading="lazy" data-shortname=":rolleyes:" />Trim it all the way in, and run a straight edge off the bottom keel and see where it contacts the foot.  Then trim it to crankshaft verticle, and do the same check.   If this hull was not for a jet, it will probably need to be raised more than an inch.  A manual jack plate is often used.Jets should not be trimmed out past verticle.  That probably only gives you two other positions to try.</blockquote>