TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Motor Shaft Length with 20" Transom, Need Advise Please
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="jtf" data-source="post: 439771" data-attributes="member: 22611"><p>Thanks, found out in time to make a long trip and buy a Weldbilt 1648 yesterday. It's a 20" transom. I was in a rush to get down the road yesterday to look at the boat, 2015 model. It was a long round trip but well worth it. </p><p></p><p> Called mid-morning to Tohatsu USA and a very good fellow in service helped me. They have both these jet shafts. He suggested a riser rail to get the two inches needed. The dealer who will set it up uses a small manual jack plate for this, will decide when ordering motor. </p><p></p><p>Thanks members, . The ribs are much stouter than I've seen in other mod vee Jons, wide rails, extra deck storage for fuel tank. Saved me quite a bit over a new hull, that will go towards powering.</p></blockquote><p></p>
[QUOTE="jtf, post: 439771, member: 22611"] Thanks, found out in time to make a long trip and buy a Weldbilt 1648 yesterday. It's a 20" transom. I was in a rush to get down the road yesterday to look at the boat, 2015 model. It was a long round trip but well worth it. Called mid-morning to Tohatsu USA and a very good fellow in service helped me. They have both these jet shafts. He suggested a riser rail to get the two inches needed. The dealer who will set it up uses a small manual jack plate for this, will decide when ordering motor. Thanks members, . The ribs are much stouter than I've seen in other mod vee Jons, wide rails, extra deck storage for fuel tank. Saved me quite a bit over a new hull, that will go towards powering. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Motor Shaft Length with 20" Transom, Need Advise Please
Top