TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
My first boat and V boat mod.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Kevin D" data-source="post: 371745" data-attributes="member: 15478"><p>Thank you for the warm welcome, I've been doing alot of work to the boat, I thought I would explain a little more about the floor, since I'm probably the only guy who's ever used green house table tops as a floor. First, I put water in the boat to find my level and to check for leaks. Marked my lines and drained it. These tops are 2' x 6', I set one in the middle, toward the back. Using a straight edge, I set it on the table top and it was perfectly lined with my marks! So i cut and made pieces to fit in the sides, alot of trimming and fitting. Then bolted them together. I cut small pieces of pvc to go to the floor for extra stability. The front part of the floor is removable for storage underneath. It all lays on rubber roofing membrane left over from the roof I put on my house a couple years ago.</p></blockquote><p></p>
[QUOTE="Kevin D, post: 371745, member: 15478"] Thank you for the warm welcome, I've been doing alot of work to the boat, I thought I would explain a little more about the floor, since I'm probably the only guy who's ever used green house table tops as a floor. First, I put water in the boat to find my level and to check for leaks. Marked my lines and drained it. These tops are 2' x 6', I set one in the middle, toward the back. Using a straight edge, I set it on the table top and it was perfectly lined with my marks! So i cut and made pieces to fit in the sides, alot of trimming and fitting. Then bolted them together. I cut small pieces of pvc to go to the floor for extra stability. The front part of the floor is removable for storage underneath. It all lays on rubber roofing membrane left over from the roof I put on my house a couple years ago. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
My first boat and V boat mod.
Top