TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
New guy with jet Jon ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="PSG-1" data-source="post: 337530" data-attributes="member: 6937"><p>Then you will either need to incorporate a spoon into your hull, or form a 'delta pad' to sit the pump lower in the water. </p><p></p><p></p><p></p><p>Also, take out the center strake for at least 3 ft in front of the pump, because this will most assuredly cause issues with cavitation. </p><p>Cut along either side of that center "V" and replace it with a piece of 1/4" aluminum flat bar, wide, and long enough to cover the cut-out area and weld a continuous seam around that piece.</p></blockquote><p></p>
[QUOTE="PSG-1, post: 337530, member: 6937"] Then you will either need to incorporate a spoon into your hull, or form a 'delta pad' to sit the pump lower in the water. Also, take out the center strake for at least 3 ft in front of the pump, because this will most assuredly cause issues with cavitation. Cut along either side of that center "V" and replace it with a piece of 1/4" aluminum flat bar, wide, and long enough to cover the cut-out area and weld a continuous seam around that piece. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
New guy with jet Jon ?
Top