TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
New impeller not pumping water?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Lynn" data-source="post: 522137" data-attributes="member: 36899"><p>35hp Johnson just purchased and it wasn't pumping out any water up top.</p><p>I put in an entire impeller kit and fired it up only to not get any water out of the top end.</p><p>Put new o-rings on the main shaft and a new rubber grommet on the copper water pipe near the lower unit but nothing nearest the engine itself.</p><p>Old impeller was really bad so could there be debris up top?</p><p>Can I remove the black plastic water spout easily to look for something plugged up or will it just break?</p><p>Impeller direction is the same as the old one and I used triple guard grease and anabolic sealant.</p><p>I held the copper water pipe with a wire so I don't think I missed the rubber grommet in the impeller housing when I slid the lower unit back in place.</p><p>Any thoughts?</p></blockquote><p></p>
[QUOTE="Lynn, post: 522137, member: 36899"] 35hp Johnson just purchased and it wasn't pumping out any water up top. I put in an entire impeller kit and fired it up only to not get any water out of the top end. Put new o-rings on the main shaft and a new rubber grommet on the copper water pipe near the lower unit but nothing nearest the engine itself. Old impeller was really bad so could there be debris up top? Can I remove the black plastic water spout easily to look for something plugged up or will it just break? Impeller direction is the same as the old one and I used triple guard grease and anabolic sealant. I held the copper water pipe with a wire so I don't think I missed the rubber grommet in the impeller housing when I slid the lower unit back in place. Any thoughts? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Motors
New impeller not pumping water?
Top