Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Lynn" data-source="post: 522167" data-attributes="member: 36899">Just took it apart again and it looks good to me. The impeller is spinning. On other forums I see mention of a thermostat housing and suspect that is my issue? The shaft was greased before it was bolted back together but I didn't see any place for an O-rings on it or do I remember taking and old one off of it?The hard plastic tube that goes over the shaft has O-rings on both ends that are new.The copper water pipe only has a rubber seal nearest the impeller and nothing at the motor is there a rubber seal missing there?After the motor is shut off water does dribble out but not much.</blockquote>