TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
New Jet Motor advice for 16’ Xpress
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="JL8Jeff" data-source="post: 471466" data-attributes="member: 12995"><p>My boat measures 23" at the transom next to the tunnel. It's about 20" at the tunnel and I had to raise the motor about 2" above the transom for the best performance/least spray and I have one more bolt hole left to go higher (but that setting was too much spray). I also have transom wedges to get it tucked in and prevent porpoising. That 4 stroke 60/40 weighs 267 lbs which is a bit heavier than my 2 stroke 60/45. With the 15" shaft, it should fit your transom raised up a couple of holes like mine. But you probably want to talk to a dealer and verify everything should work ok with your hull.</p></blockquote><p></p>
[QUOTE="JL8Jeff, post: 471466, member: 12995"] My boat measures 23" at the transom next to the tunnel. It's about 20" at the tunnel and I had to raise the motor about 2" above the transom for the best performance/least spray and I have one more bolt hole left to go higher (but that setting was too much spray). I also have transom wedges to get it tucked in and prevent porpoising. That 4 stroke 60/40 weighs 267 lbs which is a bit heavier than my 2 stroke 60/45. With the 15" shaft, it should fit your transom raised up a couple of holes like mine. But you probably want to talk to a dealer and verify everything should work ok with your hull. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
New Jet Motor advice for 16’ Xpress
Top