TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Newbie Here
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="DriftinMT09" data-source="post: 474779" data-attributes="member: 25834"><p>Went out to the boat early this morning, and cleaned off the (very poor) paint around the rear drain plug bore, wiped clean with brake clean, and applied some JB MArine weld around the outside of the bung. Noticed there were two smaller areas where it looks as if the bottom hull panel is split away from the transom panel. One area is around 2" long and the other is about 1" long. Not sure if I need to try and form those back together or just also clean and force some JB Weld into the gap.</p></blockquote><p></p>
[QUOTE="DriftinMT09, post: 474779, member: 25834"] Went out to the boat early this morning, and cleaned off the (very poor) paint around the rear drain plug bore, wiped clean with brake clean, and applied some JB MArine weld around the outside of the bung. Noticed there were two smaller areas where it looks as if the bottom hull panel is split away from the transom panel. One area is around 2" long and the other is about 1" long. Not sure if I need to try and form those back together or just also clean and force some JB Weld into the gap. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Newbie Here
Top