TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Newbie Introduction - 15' V-Hull Project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wwcenturion" data-source="post: 315444" data-attributes="member: 11760"><p>Thanks for the leaky rivet advice guys. I will try the "buck" technique first but I am not sure if the inside part is under a stringer (or whatever those supports in the bottom of the boat are called) or not. </p><p></p><p>No work on the boat today other than research. Going to do a computer mock-up of the inside that I can use to see where I want to place things and to write measurements on. </p><p></p><p></p><p>Posted some things in the WTB section: <a href="https://www.tinboats.net/forum/viewtopic.php?f=53&t=30644" target="_blank">https://www.tinboats.net/forum/viewtopic.php?f=53&t=30644</a>. I hope I didn't come off as cheap, but I want to keep the budget low on my first project int he event something goes wrong.</p><p></p><p>Thanks again for everyone;s hospitality.</p></blockquote><p></p>
[QUOTE="wwcenturion, post: 315444, member: 11760"] Thanks for the leaky rivet advice guys. I will try the "buck" technique first but I am not sure if the inside part is under a stringer (or whatever those supports in the bottom of the boat are called) or not. No work on the boat today other than research. Going to do a computer mock-up of the inside that I can use to see where I want to place things and to write measurements on. Posted some things in the WTB section: [url]https://www.tinboats.net/forum/viewtopic.php?f=53&t=30644[/url]. I hope I didn't come off as cheap, but I want to keep the budget low on my first project int he event something goes wrong. Thanks again for everyone;s hospitality. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Newbie Introduction - 15' V-Hull Project
Top