TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Ouachita 16DSV mod starting...update 4/30/13
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Ringo Steele" data-source="post: 309647" data-attributes="member: 6694"><p>The tops of the benches on mine are riveted to the sides of the bench. I just drilled out the rivets after I got it marked up for the cuts, took off the bench top and used a reciprocating saw for the cuts in the bench sides. I actually used a Dremel Tools vibrating cutter to deep-score the lines on the bench top and then snapped it off clean like breaking glass. A little file work cleaned it right up.</p><p></p><p>Got a good bit done today. The middle section is completed, and the front is designed and the sub-frame is under way. I'm sti debating on running the front v-shaped section boards linear like the rest, or running a king board and angling the rest. Decisions, decisions! #-o :mrgreen: </p><p></p><p>Anyway...here a couple more pix...(cell phone :roll: )</p></blockquote><p></p>
[QUOTE="Ringo Steele, post: 309647, member: 6694"] The tops of the benches on mine are riveted to the sides of the bench. I just drilled out the rivets after I got it marked up for the cuts, took off the bench top and used a reciprocating saw for the cuts in the bench sides. I actually used a Dremel Tools vibrating cutter to deep-score the lines on the bench top and then snapped it off clean like breaking glass. A little file work cleaned it right up. Got a good bit done today. The middle section is completed, and the front is designed and the sub-frame is under way. I'm sti debating on running the front v-shaped section boards linear like the rest, or running a king board and angling the rest. Decisions, decisions! #-o :mrgreen: Anyway...here a couple more pix...(cell phone :roll: ) [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Ouachita 16DSV mod starting...update 4/30/13
Top