TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Rivets again: rivet bucking tools.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BigTerp" data-source="post: 481410" data-attributes="member: 9169"><p>Honestly, I don't know the exact PSI. What I do is get everything setup and take the air hammer with the rivet tool installed to a scrap piece of 2x4. I set the compressor so the rivet tool just slightly dents the wood. This allows enough pressure to properly set the rivet without tearing up the head of the rivet or the aluminum of the boat. If you set your compressor too much higher than this, the rivet tool will mar up the rivet and/or the aluminum of the boat. It's best to error on the side of too little pressure versus too much. You can always bump it up as you go to find the sweet spot.</p></blockquote><p></p>
[QUOTE="BigTerp, post: 481410, member: 9169"] Honestly, I don't know the exact PSI. What I do is get everything setup and take the air hammer with the rivet tool installed to a scrap piece of 2x4. I set the compressor so the rivet tool just slightly dents the wood. This allows enough pressure to properly set the rivet without tearing up the head of the rivet or the aluminum of the boat. If you set your compressor too much higher than this, the rivet tool will mar up the rivet and/or the aluminum of the boat. It's best to error on the side of too little pressure versus too much. You can always bump it up as you go to find the sweet spot. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Boat House
Rivets again: rivet bucking tools.
Top