TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Sealing leaky rivets and seams?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Ronbedard57" data-source="post: 487279" data-attributes="member: 28449"><p>Hi,</p><p>I agree with the pro-rerivet group. If there aren't that many, I think its worth drilling out any that are suspect and bucking in new ones. This affords the chance to clean up the outer surface so there's a good seal. I bought a sack of rivets all as long as the longest ones I needed, and cut them to match the application. (ribs, seams, transom, fittings, etc.) The air tool and rivet header are cheap, and an old ball-peen hammerhead wielded by a tolerant wife got the whole job done in an afternoon. I never even considered any type of goop/sealant. Looks shoddy. Why not do it right?</p><p>I replaced dozens (the boat had been allowed to freeze up with water in the bilges), and never even tested them before painting the bottom. NO Leaks!</p><p>Wear earmuffs, and good luck.</p><p>Ron</p></blockquote><p></p>
[QUOTE="Ronbedard57, post: 487279, member: 28449"] Hi, I agree with the pro-rerivet group. If there aren't that many, I think its worth drilling out any that are suspect and bucking in new ones. This affords the chance to clean up the outer surface so there's a good seal. I bought a sack of rivets all as long as the longest ones I needed, and cut them to match the application. (ribs, seams, transom, fittings, etc.) The air tool and rivet header are cheap, and an old ball-peen hammerhead wielded by a tolerant wife got the whole job done in an afternoon. I never even considered any type of goop/sealant. Looks shoddy. Why not do it right? I replaced dozens (the boat had been allowed to freeze up with water in the bilges), and never even tested them before painting the bottom. NO Leaks! Wear earmuffs, and good luck. Ron [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Boats
Boat House
Sealing leaky rivets and seams?
Top