TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Smackdaddy's "Pole Dancer" 1652 Polar Kraft flush deck jet b
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="smackdaddy53" data-source="post: 339208" data-attributes="member: 10154"><p>Alright, got the clips riveted and the stringers cut. Now for the floor layout. I am going to run 5 full length 2x2 square tubing floor joists for the floor and extend two of them all the way to the rear of the boat to give the tunnel a little more support (I doubt it needs it but overbuilt is never bad!) and you can see this in the third picture. </p><p>Next steps are cutting the recessed parts of the decking out and getting the floor supports riveted in and more aluminum for the gunnel covers. </p><p></p><p>[ATTACH=full]59803[/ATTACH][ATTACH=full]59804[/ATTACH]</p><p>[ATTACH=full]59805[/ATTACH]</p></blockquote><p></p>
[QUOTE="smackdaddy53, post: 339208, member: 10154"] Alright, got the clips riveted and the stringers cut. Now for the floor layout. I am going to run 5 full length 2x2 square tubing floor joists for the floor and extend two of them all the way to the rear of the boat to give the tunnel a little more support (I doubt it needs it but overbuilt is never bad!) and you can see this in the third picture. Next steps are cutting the recessed parts of the decking out and getting the floor supports riveted in and more aluminum for the gunnel covers. [ATTACH type="full" alt="ImageUploadedByTapatalk1390266672.272142.jpg"]59803._xfImport[/ATTACH][ATTACH type="full" alt="ImageUploadedByTapatalk1390266683.588622.jpg"]59804._xfImport[/ATTACH] [ATTACH type="full" alt="ImageUploadedByTapatalk1390266769.189262.jpg"]59805._xfImport[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Smackdaddy's "Pole Dancer" 1652 Polar Kraft flush deck jet b
Top