Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="JMichael" data-source="post: 383758" data-attributes="member: 7544"><p>Well I've pushed, pulled, and tugged on it from every angle I can, and the only movement I can find is between the tilt adjustment pin and it's locking mechanism. I even tried to apply forward pressure to the foot of the motor (trying to simulate under power) but it wasn't enough to cause the motor to bind. I did notice that the grease that I put into the pivot fitting only comes out the bottom of the pivot shaft, and none at the top. It actually looks pretty dry at the top. Not sure if that's a problem or not.</p></blockquote><p></p>