Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Flatbotm" data-source="post: 331170" data-attributes="member: 6226">I talked about it a little on this page and you can see the finished product on this page and the next one.    <a href="https://www.tinboats.net/forum/viewtopic.php?f=21&t=20341&hilit=flatbotm+1542&start=90" target="_blank">https://www.tinboats.net/forum/viewtopic.php?f=21&t=20341&hilit=flatbotm+1542&start=90</a>I didn't go into super detail but you can get the Idea.  you won't have to lose any of the support your bench provides.  When it comes to coring out the foam the thinner the tubing the better.  I had a metal shop broom I ran over that I cut off.  The super thin walled aluminum was like a razor.</blockquote>