Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Kman1775" data-source="post: 463252" data-attributes="member: 24490">Well ....  got down to the lake today to look at the wave rider up plan on using. The height of the motor is 19 1/2 inches the total length of the pump and motor mounts is around 70 inches from front to rear. The pad is about 24 inches wide and it’s relatively flat. Thoughts : I could cut up an old super jet and reduce the length by probably 2 feet. Not sure what that does to the weight distribution. Additionally, the hull runs on a flat area about 12 inches wide . I feel it would need to be modified to more of a v to help with cavitation. Two part foam and heavy glass would be much stronger that the factory SMC (sheet molded compound) just a little FYI only use epoxy resins with when working with SMC.  Vinyl esters and polyesters will not adhere well .I think I have found the bass tracker doner hull.... tracker 1648 she a real Beauty....</blockquote>