Reply to thread

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

As cheap and easy as it is to rebuild these carbs, I'm just going to rebuild it since I have to take it most of the way apart to clean it anyway.



Thank you for the tip. I'll do that as soon as I get the fuel tank and line. Could bad gas have been causing the rattle? I know it can cause knock in a 4 stroke motor but my knowledge of two stroke is very limited.



Shift rod moved easily. I haven't checked the fluid in the LU yet. I just found out where the fluid check hole was last night while looking into changing the seals. Knowing what I know now, I would have checked before buying it, but it's a little late for that at this point.


Top