Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="trollingman" data-source="post: 502925" data-attributes="member: 34077"><p>The "v" shaped aluminum could easily have the holes drilled out to the 1/2". The outside block is the issue. Now that the holes have been reamed out in the keel the block barely covers them. I could hit it with 4200 and hope the seal will hold with a sliver of overlap between the hole and block but with the holes that big I imagine someone putting too much torque on it will flex it and break the seal.</p></blockquote><p></p>