Would anybody happen to know the part number for the Mercury water pump kit for a 2010 60/40 jet 4 cylinder? I am struggling with different numbers. Thanks
JohnnyRazorhead, How wide is your boat ? Console located where or stick steer ? Does it plane off pretty quick ?
Thanks in advance !!
It is a 1652 with a center console . I have a 9 foot front deck and a 4 foot rear deck. both are level with the sides of the boat. It is carpeted...
this is pure speculation as I do not know for sure but I bet the Blazer would be faster and lighter than the alwelds. I bought the alweld for some custom features I wanted,but the Blazer definately looks more sporty. I think it is a lighter guage aluminum than alwelds (which wouldnt make any...
I don't have the smart guages, but mine burns way more than 4.4 gph. I wish mine got that good. I only have a 10 gallon tank in my boat.
The mercury website is way confusing. I had the same questions when I was in the market to buy. T & S would tell me
one thing but the mercury site...
I'm not real sure on the GPH but I can get about 42 gps miles on 10 gallons of fuel at near wide open throttle with 2 people in
a 1652 Alweld. Just over 4 miles per gallon. My boat runs 30 to 31 gps mph so that would be near 7.5 gph......I think. :?: .
My 4 stroke turns 5000 rpm. My personal take on the 2 vs. 4 stroke on jets is very little top end difference if they are turning the same rpm. 2 stroke has slight speed advantage due to less weight. 2 stroke is much quicker out of the hole and onto plane. 4 strokes get atleast 25 to 50%...
They come from mercury with the jets already attached and carry the full mercury warranty. They have the medium jet on the 60/40. the 40 EFI jet has the same displacement as the 60 EFI motor. Both are 4 cylinder also. The mercury website is very confusing to say the least. If you think...
I have a 2010 60/40 Mercury 4 stroke jet on a 16 ft. Alweld. I bought them new from Trout and Sons. It is a 60 powerhead with 40 HP at the pump. They do come standard with a stainless impeller. My boat is completely decked out with carpet, center console, livewell, trolling motor, etc and...
The cooler water should make the jet run better. It may not be a jet problem, it sounds like possibly a carberateur
problem. ( the bogging down, that is ). If it did not cavitate before, something has physically moved or there is something in the intake. Good Luck.
Thats what it appeared to me also. I have owned a 16 and two 23's with both props and jets.
I personally never had a problem and never even heard of a prob with the smaller ones till the post above.