Stand Up's latest activity

When I ran the generator in to the panel, I had to remove the ground-neutral bonding at the generator, since it is bonded at the panel...

Got it. That makes more sense. I have a laminated instruction sheet zip-tied to mine showing the proper sequence. It's as follows...

So, I owe you all some photos as it has been a few months since I picked it up. And I noticed I don't actually have any good ones of...

I ran a parking lot for close to 2 decades here in NJ. The left side of the lot had a decent enough slope, maybe 2 degrees (doesn't...

I'm pretty wary of trade deals. I guess in the rare case you might run into a deal where both parties are looking for a better fit, but...

Have you considered a shock absorbing seat retrofit?

Looks like pretty significant water. Get a good wind blowing upstream I bet you get some decent chop. Good luck. You'll find something.

As I mentioned, I am searching for a trade, and people with deck boats are pricing them at double my bass boat's worth, so they are out...

PHD - I would think, lol

Do you have the broken nut? Do you have a set of calipers? Measure the shaft and count the threads per inch.

With some experimenting I found it is a 5/16" fine thread ( 5/16-24) . the plastic nut broke into numerous pieces, SS on their...

If you plan on the cover going over the trolling motor, your gonna need a custom made cover. If you plan on towing with the cover on you...