Stand Up's latest activity

I will give it a try in the morning. I didn't even realize these motors had a thermostat until this morning. And the little piece I...

how about trying to start it with the thermostat AND the cover OFF.. see if you get sprayed in the face...

I am running it on muffs the rectangular type and I have the hard plastic muffs and the rubber type that fit much tighter.

Impeller has a elliptical key in it and I can feel it spinning inside of the housing when I rotate the shaft by hand. I think the motor...

So I'm trying to source the neutral safety switch(0386056) for my 30hp Johnson tiller, and everything is coming up out of stock and that...

Here are a couple of pictures of my permanent boat cover setup. This is how it looks from the front quarter. Nice and tight, snow...

What year and model is the 35 Hp Johnson? Are you running it in a tank or on muffs? Does the shaft have a key way and key for the...

35hp Johnson just purchased and it wasn't pumping out any water up top. I put in an entire impeller kit and fired it up only to not get...

Just took it apart again and it looks good to me. The impeller is spinning. On other forums I see mention of a thermostat housing and...

I'm replying only so you know others are seeing your post. I have no answer for you but I'm sure someone will come up with some advice.

I always check this thread for the same reason. It's a high point of my day.