Paint it and sprinkle sand on it. The more sand you put the more grip you'll have. After sand is added and paint is dried go back over with a top coat of paint and your done
It says that you can leave it unattended and it will not hurt the battery. it is a guest pro charger 2611 i picked it up on cl for 35 bucks with no manual so i had to find it online
I recently purchased a 2 bank guest series pro charger for my boat. The manual says for a single 12 volt system or for 2 12 batteries ran parallel to connect both sets of leads to a single batterie if you only have 1 batterie to charge. The picture below is the thing I'm not sure of. I want to...
i used a piece of 1" electrical conduit with a piece of 3/4" pvc inside it.. i had to heat them as i hammered the 3/4" piece in then i put a end cap on it to keep dirt out. it works pretty good it still bends though
not sure exactly what rpm im running or what i want to go to, my motor just sounds like its not running what it should. is there some way that i can test rpm's with out having to install a tach?
I have a 2005 yamaha 15hp 4 stroke and my current prop is 91/4 x 11 I am wanting to reprop to get higher rpms. What size prop should I get? Thanks in advanced