Search results

Great find. would love to have something like that to play with. good luck with it.

I have a Sea Nymph that is somewhere in that rating and I have had my two friends on it with me many times with me in the 14 yrs. that I've had it. They are about 190 I am 175lbs. The battery is probably 40lbs. Plus I have a 15hp motor on it(75lbs ?). We go fishing and crabbing without problem...

I'll guess 1020. Scott

Hi nosticks If that should start to loosen up on you over time try what i did. Remove the thumbscrews and replace them with nuts and lock washers then just use a small ratchet with a deep socket to tighten. Keep in handy area of your liking. Also no more sore...

Bulldog That is good news to hear. Hope your Grandma has a speedy recovery.Best wishes to your family. and give grandma a hug from all of us. :) . Scott

Prayers sent to your family from mine. Scott

I have used these clamps for quite sometime and what i did was to replace the wingnut with a regular nut and then use a hacksaw and cut the threaded rod down to where i could put a socket on it and tighten it with a ratchet. (I use a deep socket) It made it much easier to to tighten the clamp...

Dave, very cool. Scott

61.3

Keep an extra plug with you or plug it from inside. mine can only be plugged from the inside.When i bought it ,it had a real small chain attatched to the handle on the plug to the knee brace. You could always carry an emergency tampon in the tackle box :lol: . Good luck with everything Scott

Is the hole the same diametor(sp?) from inside the boat to the outside? i guess what i am saying is does the plug fit if you try to install it from the inside or the outside of the boat? good luck. Scott

Not quite the manual but maybe this could help. Scott https://www.boatloader.com/

Ditto on what KMixon said and also check hitch ball for rust and sand if needed. Also check the connetor from the truck for any corrosion. Good luck!! Scott

Hi everyone I found this site last week while searching for some trailer info and decided to join. Have been doing alot of reading since then and i must say that i am impressed at the knowledege and workmanship that i have seen so far. And some of the ideas that i have seen and read are great...