97Aero
Well-known member
I have a G3 1860 CCJ and have just installed a 3 bank onboard charger in the center console. Hookups to the trolling motor batteries were only a couple of feet but I am trying to get my third bank run to the starting battery in the back. From what I can tell the wiring runs the length of the starboard side above foam on the side panels. I can get a fish tape starting in the back where the engine cables/control wring go thru the back deck almost all the way to the console but can't figure out a way for the cabling to run down from the side, under floor and back up under the console.
Do these side panels have to come off to run the wires? Looks like I would have to drill out a couple of dozen rivets to get it off and make the transition underfloor. I am stumped. Somebody ran transducer wires on this path that much I do know.
Thanks
Do these side panels have to come off to run the wires? Looks like I would have to drill out a couple of dozen rivets to get it off and make the transition underfloor. I am stumped. Somebody ran transducer wires on this path that much I do know.
Thanks