richg99
Well-known member
Jonjon...please tell us more about the "composite board" ,
thanks richg99
thanks richg99
TinBoats.net
The original aluminum boat site!
Tin boat is hot
- Thread starter bearwhiz
- Start date
Help Support TinBoats.net:
Y_J
Well-known member
Inquiring minds want to know....
Is it strong enough to mount fishing chairs to?
Is it strong enough to mount fishing chairs to?
jonjon1648
Member
I tried to put up a picture but I will need to use my desktop to upload it.
The composite board is pretty thick at just over 3/4 thick. It is also very sturdy and I have the boards attached to my benches and my chair bases attached to the board. I use the pin style bases and seat posts and don't have any flex. I am also probably the largest guys on the forum too. So far, I used this board to mount my transducer for my fish finder on the transom, I used a small piece to mount my fishfinder to the oar lock, and of course all the surfaces except the floor. I would have done the floor if I had more of it. I'd have more pictures, but I normally go fishing by myself. I'll try to post some more tomorrow.
The composite board is pretty thick at just over 3/4 thick. It is also very sturdy and I have the boards attached to my benches and my chair bases attached to the board. I use the pin style bases and seat posts and don't have any flex. I am also probably the largest guys on the forum too. So far, I used this board to mount my transducer for my fish finder on the transom, I used a small piece to mount my fishfinder to the oar lock, and of course all the surfaces except the floor. I would have done the floor if I had more of it. I'd have more pictures, but I normally go fishing by myself. I'll try to post some more tomorrow.
Similar threads
