flex
Well-known member
- Joined
- Feb 8, 2017
- Messages
- 59
- Reaction score
- 0
Hey guys, finishing up my rebuild of my old boat. I have a 1975 70hp Evinrude. With not trim but on a Jack plate. I had been thinking of just adding CMC trim when I find a local used deal some day.
Was just reading and noticed its an additional 6 inch set back. That would put me at 10" set back. And would require new steering cable. So now I'm thinking I'm better off just finding a stock unit.
My question is can somebody tell me what years and model tilt trim are compatible? And also if I can just wire tilt trim to a separate switch since my controls don't have it?
Sent from my HTC One M9 using Tapatalk
Was just reading and noticed its an additional 6 inch set back. That would put me at 10" set back. And would require new steering cable. So now I'm thinking I'm better off just finding a stock unit.
My question is can somebody tell me what years and model tilt trim are compatible? And also if I can just wire tilt trim to a separate switch since my controls don't have it?
Sent from my HTC One M9 using Tapatalk