Search results

I recently purchased a 2 bank guest series pro charger for my boat. The manual says for a single 12 volt system or for 2 12 batteries ran parallel to connect both sets of leads to a single batterie if you only have 1 batterie to charge. The picture below is the thing I'm not sure of. I want to...

I have a 2005 yamaha 15hp 4 stroke and my current prop is 91/4 x 11 I am wanting to reprop to get higher rpms. What size prop should I get? Thanks in advanced

Anyone got any pics of electric anchor mounts?

i bought a 6 gallon gas tank for 6 dollars at my local flee market. it has a little bit of rust inside but not much. how should i go about getting it out? i have seen this new stuff called "metal rescue" which takes rust out of stuff. does anyone know about it or something elece? thanks in advanced

i have heard that you can paint ply wood and then add sand to it to make it non skid. I have a question though... Does it make the wood water proof to where i can hose it down with out it soaking in the water? Also any steps/ web sites/pics/ that any of you know of or have would be helpful...

in between the bench seats in my boat i am wanting to add a rod locker but its not long enough. Is there a tube that i can put in the side of the middle bench seat that the tip of my rods can go into? Any help and pics if any please

I have an older motor guide 43# thrust bow mount trolling motor on my boat. The other night while fishing the number 2 speed quit working then today the number 1 speed quit so now I only have a 3,4,5 speeds. Is there a part or switch that I may be able to replace to get those speeds to work

i have 2006 yamaha 15hp 4 stroke and i was wondering if anyone knew the way to change from tiller steer to remote steer. i have looked and cant find a kit to do so. Any help will be appreciated!

i have alot of stains on my tracker 1542 from the waters i fish... is there any way to get them off? i have tried washing and pressure washing but no luck.

has anyone used these? i was thinking of puting 2 strips on each side of my boat and running them to 1 switch to turn on and off. Also how to you connect these to your boat? Thanks in advanced...

i found this decking a person used on a build on youtube. He put it in the floor of the boat, but i was wondering how yall think it would work as deck instead of plywood. Another question is do yall think 1/4 inch would be thick enough to support a good bit of weight...

i have a 2006 yamaha 15hp 4 stroke tiller stear and its a short shaft, i am wanting to know if there is a kit that i can buy that turns it into a long shaft motor

I am wanting to install some post guide ons on my jon boat trailer but im not sure if they will work. My trailers frame is 1" wide and 3" tall. Will the post guide ons have enough trailer to hold on to or will i have to make my trailer wider. Thanks in advanced any advice welcome

Hi all, I have a 2006 Yamaha 15 hp 4 stroke tiller steer. As of right now it is manual start, and i was wanting to know if I could add electric start to it. If so does anyone know how much that would cost. Thanks in advanced

what is the best bow stop for a flatbottom jon boat? Mine never loads or unloads without hanging up on the board and its time to solve that problem. Thanks in advanced

ok im wanting something on my boat where i can just hose it off and dont have to worry abouthaving soaked wood/ carpet would hydroturf be a good idea? also does it get real hot to the touch? any advice will help. Tanks in advanced

I have read a post on here before about this but couldnt find it again. I have a 2006 yamanha 15hp tiller steer outboard, if i dont keep alot of pressure on it it pulls to the right very hard its not just a gradual pull either it would just about toss you out of the boat if you let go of the...

HI everyone, i am in the market for a good aluminum livewell for my tracker topper 1542. I dont want it to be huge but just big enough to put a 5 fish limit of bass in it. I was interested in the fish mate pro livewell but after reading some of the post about not getting them for a couple of...

Im trying to decide wheather to purchase a regular bow light like the bass pro shops bicolored one or one of those that are on a pole. My trolling motor is bow mounted and i dont know which one would be better. Any advice

I want to buy a switch panel and mount it somewhere in my boat. I dont want to cut a big hole in my boat to do so. I have heard that radio shack sells a little waterproof box made for switch panels. Does anybody know another way or would one of these boxes work good.