Search results

Stumalump that's a good idea but I really don't want to drill holes in the bottom of my boat if I don't have too. But thanks for the idea.

The back end of the boat is swaying from side to side and won't stay straight when I am trolling motoring on a lake and it's even worse when the wind is blowing.

I am looking to get some kind of rudder for my 14' AlumaCraft Flat Bottom, but I'm not sure whether it would be easier to make my own or just buy one. Any suggestions?

I am looking for a bracket or something to install my foot controlled trolling the bow of my 14 Alumacraft jon boat. Any suggestions?

well I guess I can't upload photos on here because I sent a personal message by mistake.

I have a 14' Flat bottom and after decking it out, it seems a little unstable with two people in it. like yesterday me and my wife went out in it and she was sitting down and I was standing up and every time one of us would move the boat would rock one way or the other. I added two 50lb bags of...

When I was fishing down there they just had started dredging. There was lots of eel grass and patches of hydrilla.

The fuse holder holds up to a 20 amp fuse. I spoke with a marine place today and they said they use the same holder as me and they said to just use a smaller fuse.

Ok here goes, I have a humminbird piranha with 18 gauge wiring. I bought extra 18 gauge wiring to run to the battery. The fuse holder I bought is 20 amp and has 16 gauge wires. I and can't find any 18 gauge battery ring connectors. So my question is there any issue with connecting the 18 gauge...

I am putting two batteries in my 14' flat bottom and and I was wondering about the way weight of them being upfront or should I move them to the middle of the boat? Anyone have suggestions?

That's a great idea but my boat doesn't have a wide lip like yours to attach the bracket too.

I'm sure this has been answered before but here goes. I Have a 14' flat bottom and I am wanting mount a transom mount trolling motor on the front. I have been looking and looking for some kind of bracket that is not to expensive or some kind of idea on how to build something. Can anyone help?

I am looking at a swivel seat. But I have been looking at several different places to mount it. One is place the mount in front of the bench seat on the plywood but I worried about it being sturdy enough or mount the plate to the plywood which is attached to the bench seat.

I am looking to mount my seat in my 14' Jon boat and wanting advise on how to secure the seat to the plywood? Screws or T-nuts or toggle bolts?

I use to fishing Lake Panasoffkee a lot several years ago and I was wondering what the fishing is like down there now?

I have a 14' Jon Boat and I am using aluminum angle bar for the framing, do I use screws or rivets to attach the aluminum? also I need some ideas for the storage compartments and how to attach the foot controlled trolling motor.