Bass Tracker v17

[harleydoc]

Well it is still raining here I am about to take my boat to a buddy's shop I think tomorrow and let me shot the liner in it I just want to get her done. She not going to get done with all the rain plus it can sit in the paint booth over night and get cooked on really good so it should be tougher that away as well.

 

[harleydoc]

Well got the bedliner sprayed in her today got nice And hot here so I had to leave work at noon and get her done

 

[harleydoc]

 

[Pweisbrod]

Looks great. Rattle can?

 

[harleydoc]

No it is the pro spray in stuff extreme liners I got a three gallon kit but only used 1 1/2 gallons on it I could have went thicker but I think she will.

 

[harleydoc]

I got just about everything done I still have one more hatch to install and seal ran out if caulk. Go to get a new tank fitting for my new 9 gal fuel tank for some reason the fitting from my old tank would not work. Then I am going for a shack down and sea trials tomorrow after work. Got tue new switch Panels installed and everything hooked up. Horn even works now. I have not installed my radio yet I may get it in before shack down and sea trails tomorrow after work.

 

[Flat Bottom]

Where did you get the glass for the flooring? Im trying to think of a more permanent setup for my floor but that glass is pretty spendy isnt it?

 

[harleydoc]

Where did you get the glass for the flooring? Im trying to think of a more permanent setup for my floor but that glass is pretty spendy isnt it?

It is 1/2 ply wrapped in 2 layers of fiberglass the glass is 1.5 oz mat and I used west system resin I wanted something that was going to last for a long time. Spar need to stay on the kitchen table and not on a boat. Just my two cents worth. The price just for the resin is about 300 bucks to me two gallons of the west system at 130 for a gallon kit then about 80 bucks in for the glass mat in the long run I cut a lot of weight out of my boat and add strength to the decks.

 

[harleydoc]

Well took the boat out today the boat floats nice I think I have a bad fuel pump or need a new fitting for the fuel line on the motor side. She would not ref all the way up and then would die and the ball would he soft I could pump it back hard and it would run but would not take off. I am think it is the fuel pump I have an old motor here I am going to see if the pumps are the same and just rob the pump and fuel fittings off of and give it a shot again tomorrow if the weather hold out and is nice. But I did get her up the 28 on the GPS before she would run around 34 so I think she will fly after all the work I have done if I can get the motor running right. I lot my coast guard plate during the over haul. I don't know if it got put in the trash with a bunch of carpet or not I thought i put in the top of my tool box but who know. Does anyone know how to go about getting a new one????

 

[harleydoc]

Well replaced the fuel fitting on the motor today no more leak she ran good in the can and sea to rev all the way up like she should I guess we will see in a few day when I get her on the water I still new to get a new fuel line fittings might as well make that all new I also replace the old style fitter with and soiled one time use type of fitter I am over no one having the ones I need in stock but having a bunch of the one time uses ones plus they a few bucks cheaper.