tonynoriega
Well-known member
So the previous owner of my tinny got a little carried away with securing the plywood to the transom and drilled about 15 holes in the back.
I could just potentially use them and go the nut and bolt and washer route with a bit of 3M....
But thought it would look pretty crappy with two dozen extra bolts jabbing out all over the place on the plywood and inside the boat...
Was thinking I could just plug them with some JB Weld and with a couple coats of my Rustoleum paint, should be good.
I am concerned about the overall strength it would have. I just seems like it could "pop" out .... even though the PSI on the JB Weld is over 3000... (per the label)...
Any thoughts? Ideas.... confirmations?
I could just potentially use them and go the nut and bolt and washer route with a bit of 3M....
But thought it would look pretty crappy with two dozen extra bolts jabbing out all over the place on the plywood and inside the boat...
Was thinking I could just plug them with some JB Weld and with a couple coats of my Rustoleum paint, should be good.
I am concerned about the overall strength it would have. I just seems like it could "pop" out .... even though the PSI on the JB Weld is over 3000... (per the label)...
Any thoughts? Ideas.... confirmations?