New Member, first post

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I finally signed up here after reading the posts here for over a year or so now.
I recently retired and have decided to get back into fishing and thus boating to pass the time and hopefully put some food on the table as well.
Welcome, Loosescrew! Do you have a boat yet, or a project in line?
 
Welcome, Loosescrew! Do you have a boat yet, or a project in line?
I have a motor, sort of inherited a 15hp Evinrude.
I'm looking for a hull and trailer, something in the 14-15ft range will likely be best with this motor.
I price new, but between there being almost no new boats on the lots lately and the cost. I didn't realize that bare hulls had gotten up over $3k now. I'm pretty much just looking used now. I'll most likely just buy or build a new trailer so all I need is a hull. I've looked at a few so far but all of them so far either don't have a title or they're a salt corroded mess. The best deal I found so far is a 14ft Starcraft about 12 miles from here.
https://southjersey.craigslist.org/boa/d/vineland-14ft-starcraft-aluminum-boat/7821325674.html
I liked this one but thought I'd find something cheaper but so far all I found is either smaller, narrower, rotted, or with no papers. Its the only one that I can just hang my motor on it and go. Starcraft seems to make two 14ft boats, one is more or less just a stretched 12ft hull, and the one above, that's almost as big as a 16ft space wise. The seller also said he brought it here from PA, so its not likely been in saltwater its whole life.
The only other one I looked at was a narrower version and the transom was corrosed through in several spots up near the rear tie down loops and someone had cut out the middle bench seat leaving it with sides that flex pretty badly.
 

Latest posts

Top