smackdaddy53
Well-known member
Thanks.
No, I picked them up off a guy that had them on a Ranger Ghost poling skiff. I sense sarcasm... Bahaha
No, I picked them up off a guy that had them on a Ranger Ghost poling skiff. I sense sarcasm... Bahaha
[url=https://www.tinboats.net/forum/viewtopic.php?p=349577#p349577 said:rscottp » Yesterday, 21:46[/url]"]I like the "Oh S#*t Rails". Glad your moms surgery went well, did you unbolt the rails from the wall at the hospital?
Nope, all aluminum to attempt to keep it light.Country Dave said:[url=https://www.tinboats.net/forum/viewtopic.php?p=349577#p349577 said:rscottp » Yesterday, 21:46[/url]"]I like the "Oh S#*t Rails". Glad your moms surgery went well, did you unbolt the rails from the wall at the hospital?
Now that's funny right their I don't care who you are.................. :LOL2:
They only use I quality stainless so good call if you did... :mrgreen:
best wishes for your mom and a speedy recovery.
[url=https://www.tinboats.net/forum/viewtopic.php?p=351135#p351135 said:smackdaddy53 » Today, 09:01[/url]"]About to get the top cap on the boat and temporarily screwed down so I can fit a few pieces to be welded up at 1pm at my buds shop. Fabbing a trolling motor mounting plate on the front deck, getting the very front deck rubrail fitted, inside perimeter 2x3 angle fitted and a couple of other pieces cut and welded so I can start prepping for primer and Tuffcoat application. I bought my pneumatic texture hopper yesterday to apply the Tuffcoat with and get into those hard to reach areas. I will take some pictures as I go and post up tonight. If all goes as planned I will be priming this evening or in the morning then blowing my first coat on tomorrow by lunch hopefully. Then it is on to rigging!
Enter your email address to join: