The landing net rack I made today

[SlimeTime]

Nothin' sharp on it, the vinyl is actually a pretty soft material.

ST

 

[dedawg1149]

looks good i like it nothing like redneck engineering after seeing it on your boat i think i will do mine.

 

[Waterwings]

Nothin' sharp on it, the vinyl is actually a pretty soft material.ST

Okay. I thought it was like a hard plastic material.

 

[SlimeTime]

looks good i like it nothing like redneck engineering after seeing it on your boat i think i will do mine.

"Patent Pending" :LMFAO:

Seriously, I used a cheap holesaw kit, and it worked perfect because it cut the holes just slightly smaller than the OD of the PVC pipe, & I just used a drum sander on a drill to get the holes just large enough for a tight fit (had to tap them on whth a hammer) on the pipe. The only reason I used the pipe on that side was so I wouldn't have to fight trying to align the handle with both holes, this way I only have 1, then it's a straight-shot down.

lol......redneck engineering......it's what built this country :wink:

WW- Next time you're at the home improvement center, check this stuff out, they make trim & brickmold out of it. It's actually somewhat flexible. I bet a guy could find lots if uses for it on his boat.

ST

 

[Waterwings]

WW- Next time you're at the home improvement center, check this stuff out, they make trim & brickmold out of it. It's actually somewhat flexible. I bet a guy could find lots if uses for it on his boat.

:idea: I know what you're talking about now!