- Joined
- Aug 14, 2016
- Messages
- 6,746
- Reaction score
- 3,625
- Location
- Northern California
- LOCATION
- Northern California
Glad you circled back to share the results. That was a pretty impressive (and encouraging) patch you made.
TinBoats.net
The original aluminum boat site!
70’s Starcraft 14’ Seafarer “By Golly”
- Thread starter Makaw
- Start date
Help Support TinBoats.net:
I think that lower unit was pretty much the same from the late 1950's till the late 70's or so. It shouldn't be too hard to find a good used one to have on hand just in case. Since your lower half is good, you can likely find one even cheaper that's got a broken skeg. Something that's pretty common here.
Makaw
Well-known member
I definitely keep an eye out on a few online marketplaces. I have looked at, and found, inexpensive parts motors from years close to mine, but I was never able to confirm cross-compatibility with 100% certainty. Once or twice I saw exact match motors, but they were fairly far away. It would be nice to have an extra sitting handy if I needed it.
Makaw
Well-known member
Thanks LDUBS! It's not the easiest motor to replace, being short-shaft, electric start, and remote steering (for an early Johnson anyway), so fixing was ideal. I'm really happy that it's held up. I'll actually be salmon fishing out of it later today and tomorrow!
Makaw
Well-known member
I just noticed that I never follow up regarding the "notch" in the side console. I don't have a good picture of it, but that notch holds a carpeted insert which supports my trolling motor when it is in the stored position. When I go to launch the boat, I can remove and stow the support piece so it's not in the way.
- Joined
- Aug 14, 2016
- Messages
- 6,746
- Reaction score
- 3,625
- Location
- Northern California
- LOCATION
- Northern California
Aw, that makes sense. Best not have the TM bouncing around while towing the boat. I made a TM stabilizer out of a piece of PVC pipe that sits in a flush mount rod holder.
Makaw
Well-known member
Here's an encouragement to everyone on here fixing up an old tin floater, or thinking of fixing one up. The work of restoring can be long and tiresome, but I feel it is absolutely worth it. These boats can have so much life left in them! A friend and I probably landed over 100 pounds of Lake Michigan salmon last weekend in 1.5 days of fishing. Sure, I could probably swing the cost of a newer, nicer, bigger boat, but it feels so satisfying to add to the legacy and memories that this boat has been through over nearly 50 years in my family. Keep going strong on those builds!
*I'll add that we did not go out on the big lake, but were fishing a connected staging lake the salmon pass through before making their river run. You still have to be smart and work within the capacity of the vessel. Safe boating everyone!
*I'll add that we did not go out on the big lake, but were fishing a connected staging lake the salmon pass through before making their river run. You still have to be smart and work within the capacity of the vessel. Safe boating everyone!
- Joined
- Aug 14, 2016
- Messages
- 6,746
- Reaction score
- 3,625
- Location
- Northern California
- LOCATION
- Northern California
If there ever was the need for a case to fix up an old boat, this one pretty much seals the deal!
