canadian omc
Well-known member
Hi all,
I've recently broke one of the blades on my trolling motor It's an older Minn Kota Power Drive 765mx 28lb thrust.
So my problem is finding an replacement propeller.
I've purchased a new MKP-6 at Cabelas, however there is about 1 1/2" of exposed shaft now between the prop and the rear cap on the motor.
What, if any problems can result in using it this way? Also, the new prop is slightly larger in diameter than the original by 1" and is approximately1/4"past the bottom of the skeg.
Cheers.
I've recently broke one of the blades on my trolling motor It's an older Minn Kota Power Drive 765mx 28lb thrust.
So my problem is finding an replacement propeller.
I've purchased a new MKP-6 at Cabelas, however there is about 1 1/2" of exposed shaft now between the prop and the rear cap on the motor.
What, if any problems can result in using it this way? Also, the new prop is slightly larger in diameter than the original by 1" and is approximately1/4"past the bottom of the skeg.
Cheers.